 |
Vertical Holder - I have used this jig on the router
table. It is adjustable so that stock of different widths can be held securely.
"A" is a piece of 1 1/4" wide stock that is the same
thickness as the stock being worked. It serves as a backer board. It is attached by
three countersunk screws. Be sure that the lowest screw is out of the path of the cutter.
"B" is a piece of 1/2" MDF that has a 5/16" T-nut that is
counterbored so that head is flush with the piece.
"C" - the back board is cabinet grade birch plywood 12" wide
by 7 1/4" high.
|
